Hitachi M24SSD Uživatelský manuál stáhnout pdf

PLEASE: CALL US IF YOU HAVE DIFFICULTY BEFORE YOU

RETURN THIS TO THE STORE.

PARTS HOT LINE PHONE: 574-848-7491

ASSEMBLY and OPERATING INSTRUCTIONS

EarthWay

Ev-N-Spred

M24SSD Series Broadcast Spreader

HELPFUL HINTS:

 If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must

turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use.

Fertilizer stuck on the impeller blades will cause uneven spreading.

 Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change

the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean your spreader thoroughly after each use.

Wash between the shut off plate and bottom of the hopper.

 Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.

1. Remove and identify loose parts from carton.

PAGE 1

2. Position hopper on side. Install frame using (4) 1/4-20

x 1-1/2” Pan Head Philips machine screws and (4) 1/4-20

nylon insert locknuts. First put bolts through holes in

frame then through holes in bottom of hopper. Secure

with locknuts. Tighten these locknuts now.

1 2 3 4 5 6

EarthWay 1
HOW TO ORDER SPARE PARTS 5

Shrnutí obsahu

Strany 1 - EarthWay

PLEASE: CALL US IF YOU HAVE DIFFICULTY BEFORE YOU RETURN THIS TO THE STORE. PARTS HOT LINE PHONE: 574-848-7491 ASSEMBLY and OPERATING INSTRUCTIONS

Strany 2

4. Install gear box by inserting the pinion shaft into hole in center of hoppers bottom. The word “FRONT” on the gearbox must point to Front of the ho

Strany 3

6. In-stall drive wheel to axle using pin hole nearest to lower handles as shown. Insert 2” cotter pin through wheel and through axle. Bend with plie

Strany 4

11. Install handle shaft to lower handles and pivot & bracket assembly as shown. Using (4) 1 ½” bolts and (4) locknuts. Tighten bolts and nuts n

Strany 5 - HOW TO ORDER SPARE PARTS

16. Tension on the flow control lever may be adjusted by tightening or loosening the tension nut as shown. WARRANTY EARTHWAY guarantees this product t

Strany 6

EarthWay Products, Inc. P.O. Box 547 Bristol, Indiana 46507 (574) 848-7491 www.earthway.com ® Key # Part # Description Key # Part # Description1 40003